![]() ![]() ![]() ![]() ![]() If you do not specify either a primary or secondary flash location for the destination, the download automatically goes to primary flash. The oobm parameter is not available on switches that do not have a separate OOBM port. If this parameter is not specified, the TFTP traffic comes in through the data interface. When executed in the destination switch, downloads the software flash in the source switch's primary flash to either the primary or secondary flash in the destination switch.įor switches that have a separate OOBM port, the oobm parameter specifies that the TFTP traffic must come in through the OOBM interface. The options for this CLI feature include:Ĭopy from primary flash in the source to either primary or secondary in the destination.Ĭopy from either primary or secondary flash in the source to either primary or secondary flash in the destination.Ĭopy tftp flash ip-addr flash Where two switches in your network belong to the same series, you can download a software image between them by initiating a copy tftp command from the destination switch. The menu interface enables you to transfer primary-to-primary or secondary-to-primary. The CLI enables all combinations of flash location options. You can use TFTP to transfer a software image between two switches of the same series. Can I copy firmware from one switch to another switch in my network? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |